Net Optics Smart Filtering Appliance User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 57
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
17
*** Condential - DO NOT Distribute ***
Director
Congure Director using the CLI
You should be logged into the Director CLI. The factory-set default values for Director are:
Username: admin
Password: netoptics
IP Address: 10.60.4.180 (address for remote CLI, and for Compass manager software, when available)
Netmask: 255.0.0.0 (associated with IP Address)
Manager IP Address: 192.168.1.2 (address for SNMP traps)
Gateway IP Address: 10.0.0.1 (associated with Manager IP Address)
Display: ON
Management Port: ON
The following default parameters apply to all ports (when available):
Enable: ON
Threshold: 50%
Link Fault Detection: ON (applies to 10/100/1000 in-line Network ports only)
A complete list of CLI commands can be viewed by typing Help at the CLI prompt. It is also provided in Appendix B.
You will now use the CLI to:
Change the login User Name and Password
Assign a new IP Address, Netmask, and Gateway IP Addresses
Assign new remote manager IP Address
Change port modes
Set the date and time
Save and load Director congurations
Try out the CLI Help command
Your CLI screen should be displaying the "Net Optics:" prompt as shown here:
Net Optics>
If you do not see the "Net Optics>" prompt, try typing Help followed by the Enter key. If the prompt is still not dis-
played, repeat the instructions in the preceding section
Connect the local CLI Interface or Connect the remote
CLI Interface
and log in again.
Change Director User Name and Password
It is strongly recommended that you change the User Name and Password from the defaults to provide security against
unauthorized access.
To change the user name and password:
Enter 1. user mod name=<new username> pw=<new password>. The user name and password are changed.
Record the new user name and password in a secure location. 2.
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 56 57

Comments to this Manuals

No comments